Paxton-superchargers Plymouth Prowler Manuel d'utilisateur télécharger pdf (Page 13)

4-1

P/N: 4809629

©2003 Paxton Automotive

All Rights Reserved, Intl. Copr. Secured

22OCT02 v2.0 PlymProwler(4809629v2.0)

Section 4

INSTALLING THE OIL FEED FITTINGS

A. Using a 13mm socket, remove the three

mounting bolts that secure the power steer-

ing pump. (You can get to the bolts through

the openings in the pulley.) Let the pump

hang by the lines. Remove the oil pressure

sender using a special 1-1/16” oil pressure

sender socket. This can be found at most

auto parts stores. Install the supplied large

hex fitting using either liquid teflon or RTV

sealant. Tighten the fitting using 1-1/8”

socket or wrench. It is correctly positioned

when the large tapped hole points straight

down. Install the factory oil pressure sender

into the hex fitting using sealant. Now,

install the supplied 90º fitting into the

remaining hole. It should aim up and back,

over the oil filter. Reattach the power steer-

ing pump and attach the electrical plug to

the sender. (To get more slack in the sender

wire, carefully remove the tape securing it

near the intake manifold. This will free up

the two or three inches bundled up inside).

Attach one end of the oil feed line to the 90º

fitting and tighten. See Appendix Number

1016059.

4.1 INSTALLING OIL FEED FITTINGS

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Commentaires sur ces manuels

Pas de commentaire